Runze's New Product Launches：LM60 Series Intelligent Filling Peristaltic Pump

ABOUT LM60 series

Overview

Nowadays, the market has more stringent requirements for fluid accuracy. Thus, our company has investigated and visited a large number of customers. On the basis of LM50, a comprehensive upgrade has been carried out and a technical breakthrough has been achieved. The minimum speed is accurate to ±0.1rpm, which has reached a 10-times increase. However, the operating power is extremely low and only accounts for one-third of the LM50. It has rich application scenarios and control methods. It can support keyboard control mode, communication control mode (RS232/RS485 bus), external control mode (optional multiple signal conversion modules) and passive contact state output, with good accuracy and repeatability. It has the advantages of high efficiency, high cleanliness, convenient maintenance and simple operation and can be used manually and automatically.

Note:

1. The speed accuracy of LM60 series reaches ±0.1rpm, which is a full 10 times improvement.

2. Diversified control modes of LM60 series (support keyboard control, external control, communication control and code plate control) have changed the traditional single control form.

3. LM60 consumes lower power and has been tested by EMC laboratory and can be used normally in various harsh environments.

Product size display

Switch

Power supply

Communication Interface

Cooling fan

Product technical parameters

Product technical parameters

LM60 series pump head selection

Pump head model/pump tube model and corresponding maximum flow reference

Adapted pump head

Applicable hose

Maximum reference flow

Maximum speed

Wall thickness 0.8mm

Inner diameter 2.54mm

Note:

1. For the data under the maximum flow rate in the table, the (400rpm) in parentheses is the recommended maximum speed when using the current type of hose.

2. The recommended speed ranges of 17# and 24# hoses are below 300rpm.

3. The above test data is the flow rate measured under the condition of pure water without pressure at a room temperature of 20℃. The actual use is affected by the medium, working conditions, temperature and humidity, and voltage. The above data is for reference only.

LM60 series pump tube selection

Commonly used hose model parameter list

Model

Tube number

Tube wall thickness (metric system: mm)

Pipe wall thickness (English: inches)

Inner diameter (metric system: mm)

Inner diameter (English: inches)

Hose pressure | continuous gap

Note:

1. When selecting the pump head and pump tube, it needs to refer to the corresponding flow curve.

2. The hose has the same pipe diameter and specifications, different materials, pipe ductility, resilience, softness and hardness are different. The maximum flow is for reference only.

3. For hoses with thicker pipe walls (such as 24# pipe), the current setting can be appropriately adjusted to increase the torque at high speeds.

4. For hoses with thicker pipe walls (such as 24# pipe), they may start to lock up immediately after going up to the high speed if they stop working for a period of time. Lubricating oil is needed while it should be to work for 1 to 2 minutes in the low-speed section.

LM60 series product display

Application field

Experiment Analyzer

Medical analyzer

Environment analyzer

Food toxin inspection equipment

Chemical petroleum analysis instrument