Pump head material
42 step motor
ID0.64-3.0mm WT0.8-1.0mm OD≤5mm
●Fine appearance, compact structure, mini size for space-saving installation, low consumption
●Speed and flow rate adjustable, high stability, accurate flow, low noise, long service life
●4 rollers for moderate pulse
●Suitable for medical device and micro flow transfer device
●Label service support
Temp. upper limit
Motor Wireline Direction
BJ-RZ1030-4 Flow Rate Table
Tube size (ID*WT: mm)
BJ-RZ1030-4 Flow rate (ml/min)
1.These data are generated under room temperature without extra pressure, test media is water. Your results may vary depending on variables such as the solvent used, the material of tubing, temperature, pressure, humidity, voltage etc.
2.BJ-RZ1030-4 peristaltic pump is suitable for liquid viscosity like water or weak viscosity liquid.
3.BJ-RZ1030-4 peristaltic pump is suitable for corrosive or non-corrosive liquid when equipping different kinds of tubing, liquid only go through tubing, so tubing material is the main factor for corrosion problem.
4.2 pieces straight connectors are necessary for pump tube on BJ-RZ1030-4, or tubing will get slide when working, we will standard equip 10cm rubber tube and 2 pieces straight connectors for each pump for your order, if you need more tubes and connectors for spare use, please order them in our shop.
5.1 piece stepper motor wireline will be standard equipped for each pump for your order.
6.BJ-RZ1030-4 peristaltic pump can be controlled by ON/OFF SPEED CW/CCW control, PWM control, RS232/RS485/CAN communication control, you can find corresponding driver in our shop.
7.The stepper motor of BJ-RZ1030-4 peristaltic pump was MINEBEA imported from Japan with high reliability, if you need the manual of motor, please contact our customer service.
8.Dimension and installation sizes are within the 6 main showing pictures, please check them there.