BJ-RZ1010-2D (single channel)
BJ-RZ1010-2S (double channel)
Pump head material
42 step motor
0-339ml/min (single channel)
0-120ml/min (double channel, each channel 0-60ml/min)
ID0.64-3.0mm WT0.8-1.0mm OD≤5mm
Motor Wireline Direction
BJ-RZ1010 Flow Rate Table
Tube size (ID*WT: mm)
BJ-RZ1010-2D Flow rate (ml/min)
BJ-RZ1010-2S Flow rate (ml/min)
1.These data are generated under room temperature without extra pressure, test media is water. Your results may vary depending on variables such as the solvent used, the material of tubing, temperature, pressure, humidity, voltage etc.
2.BJ-RZ1010 peristaltic pump is suitable for liquid viscosity like water or weak viscosity liquid.
3.BJ-RZ1010 peristaltic pump is suitable for corrosive or non-corrosive liquid when equipping different kinds of tubing, liquid only go through tubing, so tubing material is the main factor for corrosion problem.
4.2 pieces straight connectors are necessary for pump tube on BJ-RZ1010, or tubing will get slide when working, we will standard equip 12.5cm rubber tube and 2 pieces straight connectors for each pump for your order, if you need more tubes and connectors for spare use, please order them in our shop.
5.BJ-RZ1010-2D need to install 1 pieces 12.5cm pump tube and 2 pieces straight connectors.
BJ-RZ1010-2S need to install 2 pieces 12.5cm pump tube and 2 pieces duplex fittings.
6.1 piece stepper motor wireline will be standard equipped for each pump for your order.
7.BJ-RZ1010 peristaltic pump can be controlled by ON/OFF SPEED CW/CCW control, PWM control, RS232/RS485/CAN communication control, you can find corresponding driver in our shop.
8.The stepper motor of BJ-RZ1010 peristaltic pump was MINEBEA imported from Japan with high reliability, if you need the manual of motor, please contact our customer service.
9.Dimension and installation sizes are within the 6 main showing pictures, please check them there.