Home > News > Content

Manufacturing Process Of Tee Joint

- Jan 12, 2018 -

The tee joint is formed to be a tube billet larger than the tee diameter, the size of the diameter of the tee is flattened, and a hole is opened in the part of the stretching branch tube, and the tube billet is heated and put into the forming mould, and the die of the drawing branch tube is loaded in the Tube billet, and the tube billet is compressed radially under the action of pressure, In the process of radial compression, the metal flows toward the branch pipe and forms the branch tube under the drawing of the die.

The whole process is formed by the radial compression of the tube billet and the stretching process of the branch tube part, unlike the hydraulic bulging tee, the metal of the Tee Joint branch is compensated by the radial motion of the tube billet, so it is also called the radial compensation process.

As a result of the use of heating to suppress the three-wire, material forming required equipment tonnage reduction, hot-pressing tee on the material adaptability is wide, suitable for low-carbon steel, alloy steel, stainless steel materials, especially large diameter and thick pipe wall of the tee, usually using this forming process.


Related News

Related Products

  • Change Over Valve
  • Two Way Selector Valve
  • Pump Head Replacement
  • Micro Peristaltic Pump
  • 24V Peristaltic Pump
  • Stepper Peristaltic Pump